Categories: Audio

“Hum” Remover

Here is the hum remover circuit diagram. “Hum” usually occured from live audio system, for example: input from microphone. Hum can be removed from an audio signal to get the maximum performance by mixing the actual hum with an antiphase hum in equal level. You can use any NPN transistor to support this circuit.

VR1 adjusted with VR2 until the hum is at minimum. SW1 may have to be changed over, then adjust VR2, is altered until the hum is removed.

This circuit is an active circuit that worked with 9-15V DC supply. Stabilized and regulated power supply is necessary for maximum performance.

Block diagram of hum remover:

circuit diagram

Share
Published by
circuit diagram

Recent Posts

Guitar Synthesizer Schematic Diagram Collection

Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…

54 years ago

Handy Talky HT DIY Schematic Diagram

Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…

54 years ago

Doorbell Ringer Birdie Tone

This is an old or "very old" schematic diagram of birdie tone or sound generator.…

54 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

54 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

54 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

54 years ago