This is a 200W power amplifier circuit project. The circuit features high power, good definition and very low noise. It delivers about 200 watts in 4 ohms loudspeaker: a 4 ohm speaker or two pieces of 8 ohm speakers in parallel. This 200W power amplifier using the complementary transistors of 2SC5200 and 2SA1943 as the main parts.
If you use it with only one 8 ohm speaker, it will deliver a power of 100w. The printed circuit board has the following measures: 13.6 cm x 13.9 single sided. The power supply used for this circuit is a symmetrical type which capable to delivers ± 50 VDC by 4 Amperes to the circuit. The power supply schematic is included in this board.
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
Hi,
I made this circuit but right side TIP42 and TIP41 get hot when input small signal, any tips to troubleshoot?
Thanks,
Maashallah