This is a very interesting circuit design to assemble. There are 4in1 amplifier module in a circuit board. 100W power amplifier using the TDA7294, for the VU meter uses IC LM3914. The tone control preamp uses the well-known IC 4558. The symmetrical power supply module also included in the PCB.
Active Components
Resistors
Capacitors
Component Placement
This is a single channel (mono) audio system. For stereo audio system, you need two similar circuit and make some changes such as: use higher transformer current, higher diode current, higher capacitor value for the power supply module. Use only one power supply. Use stereo potensiometer and connect to the two boards using cable.
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
can u send pcb figure to my mail
abhinavrqz@gmail.com