This is the circuit diagram of sound effects generator. All sounds in this circuit are generated by HT2884. The HT2884 is a CMOS LSI chip equipped with tone circuit, noise circuit, and other control logic to generate various sounds to be used in sound effects production. This IC features: single power supply (2.4V ? 3.3V), low stand current, auto power-off function, and eight different sound sections. There are 8 different sound effect can be produced that are 2 lazer guns, 1 dual tone horn sound, 2 bomb sounds, 2 machine gun sounds and a rifle shot sound.
Circuit Notes:
This circuit works with a 3 Volt battery or 2 pieces 1.5V battery wired in series, but the IC will work with any voltage between 2.5 and 5 Volts. Switch S1 is the on / off switch. The output at pin 10 is amplified and drives a small 8 ohm loudspeaker. Pressing S3 once will generate all the sounds, one after another. S2 can be used to produce a single sound effect, next depression gives the next sound effect. Standby current is about 1 uA at 3 Volt, so battery life is very economical.
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
Could this IC be used to produce sounds at a higher frequency of
15Khz ~ 25Khz, to drive away large animals WITHOUT disturbing
the neighborhood. If so component details please.
Ronald Fonseka
Sri Lanka
thank u