This is a simple audio pre-amplifier circuit using single transistor 2N3904.
This easy circuit provides good gain to weak audio signals such as electret microphone. Use it in front of an RF oscillator to make an RF transmitter that’s very sensitive to sound. Power supply used for this circuit is wide range from 3VDC to 9VDC, you may choice the middle range about 6VDC to minimize the risk, safety purpose 🙂
Components List:
R1 = 10k R2 = 100k R3 = 10k C1 = 0.1uf or if you prefer 104 or 100n C2 = 0.1uf or if you prefer 104 or 100n Q1 = 2N3904 MIC1 = a common electret microphone
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
Awesome circuit, worked perfectly. Thanks!
Awesome circuit, worked perfectly. Thanks!
can I use this circuit with the output as an analog input to an Arduino ? thanks in advance for the reply ....
It works great for microphones. Perfect for small audio applications.
Can I use this circuit for amplifying signals from an ultrasonic receiver ?
hi dir i bult mic pre with lm 358 1k 100k feedbeak risister atach with pc 9volt powersupply his rang is vare low but iwant rang 1 feet whate i do my mic rang 1 feet chang feedback risistens or in put resistence or bult other bufer
Hi can u plz plz plz help me,i own a nokia phone that has a very low sound volume.so i want to make a very tiny sound amp that i can attatch to a very small speaker so i can hear louder and better sound quality.plz respond so i know if this is possible thanks