This is the circuit diagram of a voice operated relay. It similar with sound activation switch circuit which will turn on and turn off (connect and disconnect) the switch depending on the sound input. The output switch of this circuit is act by a relay.
Components list:
R1, R7 : 1K R2, R4, R8 : 10K R3 : 2K2 R5 : 1M R6 : 200K R9 : 39K D1, D4 : 1N4004 D2, D3 : 1N4148 C2, C5 : 2.2uF/16V mini ecap | C1 : 10uF/16V mini ecap C4 : 100pF C3 : 100nF Q1 : BC548 IC1 : LM358 (of Hitachi HA17358) 8 pin IC socket Relay : AX-SH-112L LED 3mm Electret microphone |
This mini-VOX – voice operated relay – is based on a circuit published in Silicon Chip, 9/1994, p31.
The off delay time may be adjusted by varying R3 and R4. Reducing R3 will result in a longer release time.
You could change the release time constant (C2 & R5) to say 30 seconds and use the VOX as a light switch with this delay time before turning off. Increase C2 to say 10uF and R3 to 3M3.
To make the easy adjustment, you may use potensiometer or trimpot to varying the value of resistor. You will need additional place on the PCB but it will easier for you to make some adjustment.
The kit of this circuit available at kitsrus.com and electronickits.com, you may buy the circuit there.
Below document is the manual instruction of this mini voice operated relay circuit (download) :
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
hello
which sound will activate this circuit,is it any sound?