This is the schematic diagram of LPG gas leakage sensor alarm. The circuit operates off a 9V PP3 battery. Zener diode ZD1 is applied to convert 9V into 5V DC to drive the gas sensor module.
The SEN-1327 gas sensor module from RhydoLABZ is applied in this circuit. Its output goes higher when the gas amount reaches or exceeds specific point. A preset within the module is utilized to set the threshold. Interfacing with the sensor module is performed by a 4-pin SIP header.
MQ-6 Gas Leakage Sensor Device
An MQ-6 gas sensor is applied in the gas sensor module. As per its datasheet, it has great sensitivity to propane, butane, isobutene, LPG and all-natural gas. The sensor can also be implemented to detect combustible gases, especially methane.
This circuit has been tested with LPG gas and was observed to do the job satisfactorily.
Whenever there’s LPG concentration of 1000 ppm (parts per million) in the spot, the OUT pin of the sensor module goes higher. This signal drives timer IC 555, that is wired as an astable multivibrator. The multivibrator generally works as a tone generator.
Output pin 3 of IC 555 is hooked up to LED1 and speaker-driver transistor SL100 via current-limiting resistors R5 and R4, respectively. LED1 glows and also the alarm sounds to alert the user of gas leakage. The pitch of the tone could be adjusted by varying preset VR1. An appropriate heat-sink should be used for transistor SL100.
This LPG gas leakage sensor alarm electronic project is downloadable in PDF version.
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
