This is a basic and very simple low power inverter to convert 12V DC to 120V AC. How much power this simple inverter can handle the load depends the transformer current value and transistors you use for Q1 and Q2.
Inverter 12V DC to 120V AC Component List:
C1, C2 : 68 uf, 25 V Tantalum Capacitor
R1, R2 : 10 Ohm, 5 Watt Resistor
R3, R4 : 180 Ohm, 1 Watt Resistor
D1, D2 : HEP 154 Silicon Diode
Q1, Q2 : 2N3055 NPN Transistor (see “Notes”)
T1 : 24V, Center Tapped Transformer
Misc:
Wire, Case, Receptacle (for output)
Fuses, Heatsinks, etc.
Note: Don’t try to run inductive loads (motors) using this inverter.
More explanation about how its work and the component list about this simple power inverter, visit this page
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
I have a secondary cell of 12 V.Now I want to glow a 220V ,20watt bulb.please send me the circuit diagram.
i still student,please iwant you to sent me the simple diagram of d.c to a.c circuit.
circuit
can u tell me values of resistors n capacitors used in dis ckt?
do you have any bigger siz inverter circut digram?
but all circut digram is very nice.
iwant to download circut digram of inverter