Simple Inverter 12V DC to 120V AC

This is a basic and very simple low power inverter to convert 12V DC to 120V AC. How much power this simple inverter can handle the load depends the transformer current value and transistors you use for Q1 and Q2.

Inverter 12V DC to 120V AC Component List:
C1, C2 : 68 uf, 25 V Tantalum Capacitor
R1, R2 : 10 Ohm, 5 Watt Resistor
R3, R4 : 180 Ohm, 1 Watt Resistor
D1, D2 : HEP 154 Silicon Diode
Q1, Q2 : 2N3055 NPN Transistor (see “Notes”)
T1 : 24V, Center Tapped Transformer
Misc:
Wire, Case, Receptacle (for output)
Fuses, Heatsinks, etc.

Note: Don’t try to run inductive loads (motors) using this inverter.
More explanation about how its work and the component list about this simple power inverter, visit this page

circuit diagram

View Comments

Recent Posts

Guitar Synthesizer Schematic Diagram Collection

Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…

54 years ago

Handy Talky HT DIY Schematic Diagram

Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…

54 years ago

Doorbell Ringer Birdie Tone

This is an old or "very old" schematic diagram of birdie tone or sound generator.…

54 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

54 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

54 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

54 years ago