Categories: AudioPre Amplifier

HiFi Audio Pre-amp

This is a HiFi pre-amplifier circuit diagram with low noise output. Very wide range frequency from about 10Hz until up to 100Khz? will be gained by this preamplifier for maximum audio performance. This circuit uses BC550C / BC560C transistors as active component. Use regulated power supply 15VDC for maximum result.


Here the response of the preamp’s frequency and phase:

Here the diagram of total noise at output, measured with 600R load:

circuit by Graham Maynard

circuit diagram

View Comments

Share
Published by
circuit diagram

Recent Posts

Guitar Synthesizer Schematic Diagram Collection

Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…

54 years ago

Handy Talky HT DIY Schematic Diagram

Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…

54 years ago

Doorbell Ringer Birdie Tone

This is an old or "very old" schematic diagram of birdie tone or sound generator.…

54 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

54 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

54 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

54 years ago