Car Alarm Simulator

This is a car alarm simulator which using the LED as a simulation output. This simple circuit can tell you whether your car is running or not by detecting the voltage difference when the car is on and off. This occurs because when your car is running the Alternator puts a out a voltage a little bit higher than when the car is off. This circuit comes with low current consumption of 12mA max and run with 12V only.

The circuit will be activated automatically when the engine is turned off.

How to run the circuit:

  1. Connect the circuit to the car electrical system.
  2. Adjust RV1 until the LED flashes when the engine is not running
  3. Start the engine, the LED should turn off. If the LED still on, the andjust the RV1 slighty

This circuit actually is a kits, you can get the kits at http://www.electronickits.com/kit/complete/surv/vemk126.htm. But it is very possible to you to build your own car alarm simulator circuit.

Download the car alarm simulator circuit kit manual / instruction from below link:

circuit diagram

View Comments

Recent Posts

Guitar Synthesizer Schematic Diagram Collection

Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…

54 years ago

Handy Talky HT DIY Schematic Diagram

Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…

54 years ago

Doorbell Ringer Birdie Tone

This is an old or "very old" schematic diagram of birdie tone or sound generator.…

54 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

54 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

54 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

54 years ago