The following scheme diagram is the battery charger circuit for 6V Gel Cell battery type only.
Components List:
R1 = 22 ohm, 1W R2 = 270 ohm R3 = 220 ohm *R4 = 715 ohm, 1% *R5 = 3.57K, 1% *R6 = 1.40K, 1% *R7 = 1.47K, 1% | C1 = 0.1uF, ceramic C2 = 0.1uF, ceramic D1 = 1N4001 T1 = TIP31A, B, C (or equivalent) U1 = NE555V (or equivalent) S1 = Toggle switch, ON-OFF |
* Resistors are carbon type, 1/4 watt, 5% tolerance, unless otherwise indicated.
Circuit explanation:
This circuit requires a regulated 10V-DC front end capable of supplying 2 Amps electric current, you should build this kind of power supply first. Begins the charge period at 240mA and at full charge switches automatically to a float condition (trickle charge) of 12mA. The capacitors should be the ceramic 50V (or greater) model.
Switching transistor T1 is an NPN, Si-Power Output/SW, with a TO-220 case and can be changed by using a appropriate substitute such as the NTE291, ECG291, etc. Timer/Oscillator U1 is a 8-pin NE555V and can be changed with a NTE955M or ECG955M. Resistors R4, R5, R6, and R7 are 1% metal film types. They may not be obtainable at your nearby Radio Shack/Tandy retailer and need to be ordered in. Try Electro-Sonic or Newark Electronics supply stores.
NOTE: This circuit is only designed for 6-volt, 1.2Ah Gel Cell type batteries!
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…