The following diagram is the circuit diagram of 20 band stereo graphic equaliser which will controlling the audio signal in specific frequency range.
The power supply used for this circuit is symmetrical (dual polarity) type, 15V DC.
This circuit must be connected before the amplifier circuit. For maximum performance, you may use high quality electronic component such as metalfilm resistor, MKM capacitor (nonpolar), tantalum capacitor (bipolar). You may replace the power supply module with regulated and stabilized power supply or just add IC LM7815 after R35 and IC LM7915 after R36. With good components and good power supply, then the sound quality will get better. This circuit uses 6x IC TRX6221, if you can’t find this IC at your area then you may try NE5532 or LM833 operational amplifier IC.
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…