This is an 250mW RF power amplifier circuit project. This circuit is designed to amplify the output of about 7mW wide band FM transmitters to a final level of about 250mW. General purpose 12V DC power supply can be used to operate this RF amplifier circuit.
Schematic Diagram:
Components List:
R1 ____________________ 10R R2 ____________________ 470R R3 ____________________ 47R R4 ____________________ 120R R5 ____________________ 2K2 R6 ____________________ 4K7 R7 ____________________ 22R Q1 ____________________ 2N2369 Q2 ____________________ 2N4427 Q3 ____________________ 78L08 |
C1, C11 _______________ 10n C2 ____________________ 220u/16V C3 ____________________ 33p C4 ____________________ 47p C5, C6, C7, C8, C9 ____ 1n C10 ___________________ 10u/25V L1 ____________________ 5 turn coil L2 ____________________ 3 turn coil L3 ____________________ Ferrite L4, L5, L6 ____________ RFC |
This electronic circuit is a simple 2-transistor VHF power amplifier, with about 16dB gain, and requires no tuning or alignment procedures. Wideband techniques have been used in the design and the circuit is equipped with a “lowpass” filter to ensure good output spectral purity. The project has been designed for assembly on a single-sided printed circuit board. The circuit is specifically designed to amplify the output of 7mW to 10mW WBFM transmitters (wide band) to a final level of 250mW to 300mW, after the filter.
The kit of this power amplifier circuit is available at kitsrus.com. You may download the kit manual including the information of schematic diagram, components list, and circuit works from the following link:
