This 200 Watt high quality power audio amplifier will give you top class quality for loudspeaker 4 – 8 ohm. Frequency range 20-20000Hz, Voltage 24-36V with current max 5A. You need heatsink to keep the transistor from overheating.
Itu use dual polarity power supply to work, then you may use this power supply to supply the circuit. Use 5A transformer with center tap output, change the diode with bridge diode 5A, use capacitor minimum of 6800uF/63V for better output supply.
Schematic diagram:
Component part list:
Description:
Top PCB Layout:
Bottom PCB Layout:
Good luck in bultd 200W high quality audio amplifier project 🙂
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
its amazing
IS THIS REALLY WORKS????
please help me build the transformer myself.
Please help me build an equalizer circuit(from 5-20 bands) of high quality but low cost for the 200w amp.
this ckt is not working
plz upload another ckt..
nice circuit from Bali-Indonesia