This is a 18 Watt audio amplifier circuit based on power IC HA13118. The supply voltage required for this circuit is 8 – 18V DC, at least 1 to 2 Amps. Maximum output power will only be obtained with a power supply of 18V at greater than 2 A, using a 4 ohm speaker. The power supply should be well filtered to reduce mains hum, a regulated supply will reduce noise even further. Extra filtering is unnecessary if operating from a battery supply.
Components List:
Resistors : R1, R2 ___________________ 2R2 ohm Capacitors : C1, C2, C4, C5, C6 _______ 100uF/16V electrolytic capacitor C3 _______________________ 10uF/16V electrolytic capacitor C7, C8, C12 ______________ 100nF C9 _______________________ 2,200uF/25V electrolytic capacitor C10 ______________________ 1uF/50V electrolytic capacitor C11 ______________________ 100pF Misc. I.C. _____________________ HA13118 Heatsink
C10 is the input coupling capacitor and blocks DC from the input. C11 bypasses any RF which may be present at the input. C1 & C2 provide an AC ground for the inverting inputs of the IC. R1/C7 and R2/C8 provide a high frequency load for stability with difficult speakers. C5 and C6 provide “bootstrap” feedback for the IC. C9 and C12 provide power supply filtering. Don’t forget that heatsink is a must for this class AB power amplifier circuit.
18 Watt Audio Amplifier Specifications :
D.C. Input : 8 ? 18V at 1 - 2 A Power output : 18W maximum, 4 ohm load, 18V DC supply > 10W RMS 4 ohm load, 18V DC supply > 5W RMS 8 ohm load 18V DC supply > 6W RMS 4 ohm load 12V DC supply S/N ratio : > 70 dB THD < 0.2% @ 1W Freq. Response : ~ 30 Hz to 30 kHz, ?3 dB Input level : < 25 mV, for full output (G > 50dB) Input Impedance ~ 30 k ohm
Download 18 Watt Audio Amplifier with HA13118 full explanation:
Download HA13118 datasheet:
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…