This is the very simple circuit diagram of 150W power amplifier. The circuit is easy enough to built without PCB. The power output range is about 100-150W depends to the power supply and the Darlington’s you use for the amplifier. Heatsink is a must since the final transistor is going to hot when the amplifier is activated.
The amplifier requires split power supply. The transformer is depending to your home electrical installation, it can be 110V or 220V primary. Use 35V-0-35V secondary (transformer output), you will get about 45V DC output from transformer 35V AC after rectified by the diodes. The Transformer current output should be at least 4A for better audio performance. Use 4A / 100V diodes.
Here the split power supply for 150W power amplifier:
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
What watts the other resistor did use?
Circuit is tested and working grate. I thing the stability for long hours running is not enough. It will not produce 150W into 8Ohms load.
This is a proven circuit. You can follow circuits today for improvement in design for Stability. The PCB design is also available for the improved design from Payne for reasonable price.
This was not working... I etched a PCB without testing before, and it was useless now...