The following is a circuit of a power amplifier 140W. This Circuit using 741 IC-based circuit opAmp as strengthening early before the final strengthening by four transistors thereafter. Make sure you use a heatsink on the transistors to reduce excess heat in the transistors.
Power supply used is the type of dual polarity power supply with (+), (-) and (0). For maximum performance, use a stabilized power supply with 40V output voltage and output current of 5A. Do not forget to use the good speakers to get good audio output as well .. 🙂
Good luck …
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
wrong emitter collector tap in the output pnp transistor..the emitter should be tap in the resistor .47 going to vcc section
this is good circuit diagram but something wrong look this NPN , PNP the No. of 2n3055 & mj2955 and the all. transistor.
Thank you
140 watts amp diagram layout