This is a mono power amplifier circuit powered with single Amplifier chip STA5100. The chip will deliver single power output at 140 watt. For stereo application, just build two identical circuit and then doubled the power supply current output by increase the current value of the transformer. This amplifier powered using dual polarity (symmetrical) power supply.
140W Power Amplifier Circuit Diagram:
The circuit contains all the blocks to build a mono amplifier. It is based on the Output Bridge Power Amplifier, and its protection circuit. Moreover, the compression function and a signal rectifier are added to complete the circuit.
The operation modes are driven by The Turn-on/off sequence block. In fact the IC can be set in three states by
the Stby/mute pin:
Standby ( Vpin < 0.8V), Mute (1.6V < Vpin < 3V), and Play (Vpin > 4V).
In the Standby mode all the circuits involved in the signal path are in off condition, instead in Mute mode the circuits are biased but the Speakers Outputs are forced to ground potential.
Download the STA5100 datasheet from below link to know the characteristic of STA5100 140W audio amplifier chip:
[wpdm_file id=70]
Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…
Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…
This is an old or "very old" schematic diagram of birdie tone or sound generator.…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…