Categories: Power Electronics

1.5V and 9V Battery Tester

Here is the circuit diagram of battery tester designed by Matthew B.. This circuit can be used to measure the 1.5V and 9V battery. The circuit is very-very simple and very easy to built since it uses five resistors and a panel meter only, and of course it is inexpensive too.

Components List:
R1 = 18K Ohm
R2 = 240 Ohm
R3 = 8.2K Ohm
R4 = 3K Ohm
R5 = 10 Ohm
M1 = Panel Meter (Anyone will work)

Design Issues to consider:
It’s possible you have test with the values of R3 and R4 to have a precise reading from the meter. Every meter is different, so a little bit of experiencing using the resistor values is needed. Experiment by using a variable resistor instead of R3 & R4 to get a value of resistance that works.

circuit diagram

View Comments

Share
Published by
circuit diagram

Recent Posts

Guitar Synthesizer Schematic Diagram Collection

Guitar Synthesizer Schematic Diagram In this post, we provide a collection of schematic diagrams of…

54 years ago

Handy Talky HT DIY Schematic Diagram

Handy Talky Schematic Diagram This is an old electronic scheme of the Handy Talky (HT)…

54 years ago

Doorbell Ringer Birdie Tone

This is an old or "very old" schematic diagram of birdie tone or sound generator.…

54 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

54 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

54 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

54 years ago